2026-06-01T12:20:07Zhttps://riuma.uma.es/rest/oai/request

oai:riuma.uma.es:10630/238882026-02-03T11:25:49Zcom_10630_2254col_10630_37953

Jiménez-Gómez, Carmen Pilar Cecilia-Buenestado, Juan Antonio Alba Rubio, Ana Carolina Cassidy, Andrea Moreno-Tost, Ramón García-Sancho, Cristina Maireles-Torres, Pedro Jesús 2022-03-23T08:19:19Z 2022-03-23T08:19:19Z 2022 Jiménez-Gómez, C.P. et al. (2022) “Tailoring the selectivity of Cu-based catalysts in the furfural hydrogenation reaction: Influence of the morphology of the silica support,” Fuel, 319, p. 123827. doi:https://doi.org/10.1016/j.fuel.2022.123827. https://hdl.handle.net/10630/23888 https://doi.org/10.1016/j.fuel.2022.123827 Cu nanoparticles were incorporated on different porous silica supports (commercial silica, SBA-15 synthesized both at room temperature and under hydrothermal conditions, and mesocellular foam) by the strong electrostatic adsorption method and tested in the gas-phase furfural hydrogenation for the production of furfuryl alcohol and 2-methylfuran, being the latter a promising biofuel. The incorporated copper species provided metal particle sizes lower than 5 nm in all cases. However, different catalytic behaviors, both in terms of conversion and selectivity, were detected due to the morphology and textural properties of each support. Cu over commercial silica was more prone to suffer from deactivation, and it provided higher furfuryl alcohol yields, probably due to its higher acidity and lower metallic surface area. On the other hand, the agglomeration of Cu nanoparticles together with larger pore sizes complicated the access of furfural to the active sites using the hydrothermal SBA- 15 support, thus decreasing the activity. In contrast, the addition of fluoride in the synthesis of mesoporous silica, which shortened the length of the silica channels (mesocellular foam), facilitated the furfural access and provided both higher metallic surface area and lower acidity. This fact led to a more gradual deactivation, still attaining high values of furfural conversion and 2-methylfuran yield (95 and 76%, respectively) after 5 h at 190 ◦C. However, Cu over mesocellular foam changed its selectivity pattern along 48 h and after regeneration, increasing the furfuryl alcohol selectivity due to the decreased number of available active sites. eng open access Catalizadores metálicos Tailoring the selectivity of Cu-based catalysts in the furfural hydrogenation reaction: Influence of the morphology of the silica support journal article