Effect of Co-solution of Carbon Precursor and Activating Agent on the Textural Properties of Highly Porous Activated Carbon Obtained by Chemical Activation of Lignin With H3PO4 - Moulefera, Imane; García-Mateos, Francisco José; Benyoucef, Abdelghani; Rosas-Martínez, Juana María; Rodríguez-Mirasol, José; Cordero-Alcántara, Tomás (Frontiers Media, 2020)
This work analyzes the effect of co-solution of carbon precursor and activating agent on the textural and surface chemistry properties of highly nanoporous activated carbons obtained by chemical activation of Alcell lignin with phosphoric acid. The success of this methodology highlights the possibility of directly using the liquors produced in organosolv process (Alcell) to prepare activated carbons by chemical activation with phosphoric acid. Co-solutions of lignin and phosphoric acid were submitted to a two steps thermal treatment, which consisted of a first oxidative treatment in air at 200C, followed by a thermal treatment in N2 at 400C, where activation of the oxidized lignin with phosphoric acid took place. A lignin-derived activated carbon with very high apparent surface area (2550 m2/g) and pore volume (1.30 cm3/g) was obtained with an initial phosphoric acid to lignin mass ratio of 2. Up to now, this is one of the highest values of apparent surface area reported not only for activated carbons prepared from lignin, but even for porous carbons prepared by chemical activation of other lignocellulosic materials with phosphoric acid. The use of lignin and phosphoric acid co-solution provided larger and more homogeneous effective interactions between the carbon precursor and the activating agent, by the formation of phosphate esters in the lignin matrix, which seems to be a key factor in the subsequent treatments: promoting crosslinking reactions in the carbonaceous matrix during the oxidative treatment in air at 200Candenhancing the development of a wide porosity during the following activation thermal treatment.
RTI2018 097555-B-I00 UMA18 FEDERJA-110
Keywords: Fibras de carbono; Hilatura; Ácido fosfórico; Alcell lignin; Chemical activation; Phosphoric acid; Co-solution; Activated carbon; Phosphates esters; High surface areas