Mostrar el registro sencillo del ítem

dc.contributor.authorMárquez-Segura, Enrique 
dc.date.accessioned2019-07-16T07:23:57Z
dc.date.available2019-07-16T07:23:57Z
dc.date.created2019
dc.date.issued2019-07-16
dc.identifier.urihttps://hdl.handle.net/10630/18053
dc.description.abstractIn this paper the outline of using of low-cost additive manufacturing FDM/FFF technology to build waveguide devices is presented. The focus is set in a full design from specifications to final measurements in a microwave teaching laboratory. Final results obtained asses that this experience is an extraordinary opportunity for students to get involved in waveguide technology. In addition, the use of 3D design software enriches the curricula of electronic engineering students.en_US
dc.description.sponsorshipUniversidad de Málaga. Campus de Excelencia Internacional Andalucía Tech.en_US
dc.language.isoengen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.subjectElectromagnetismoen_US
dc.subject.otherAdditive manufacturingen_US
dc.subject.otherTrl calibratinen_US
dc.subject.otherMicrowave laboratoryen_US
dc.titleAdditive manufacturing of rectangular waveguide devices for teaching microwave laboratoryen_US
dc.typeinfo:eu-repo/semantics/preprinten_US
dc.centroE.T.S.I. Telecomunicaciónen_US
dc.relation.eventtitleThe 7th Advanced Electromagnetics Symposiumen_US
dc.relation.eventplaceLisboaen_US
dc.relation.eventdate24/07/2019en_US
dc.rights.ccAttribution-NonCommercial-NoDerivatives 4.0 Internacional*


Ficheros en el ítem

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem

Attribution-NonCommercial-NoDerivatives 4.0 Internacional
Excepto si se señala otra cosa, la licencia del ítem se describe como Attribution-NonCommercial-NoDerivatives 4.0 Internacional