JavaScript is disabled for your browser. Some features of this site may not work without it.

    Listar

    Todo RIUMAComunidades & ColeccionesPor fecha de publicaciónAutoresTítulosMateriasTipo de publicaciónCentrosDepartamentos/InstitutosEditoresEsta colecciónPor fecha de publicaciónAutoresTítulosMateriasTipo de publicaciónCentrosDepartamentos/InstitutosEditores

    Mi cuenta

    AccederRegistro

    Estadísticas

    Ver Estadísticas de uso

    DE INTERÉS

    Datos de investigaciónReglamento de ciencia abierta de la UMAPolítica de RIUMAPolitica de datos de investigación en RIUMAOpen Policy Finder (antes Sherpa-Romeo)Dulcinea
    Preguntas frecuentesManual de usoContacto/Sugerencias
    Ver ítem 
    •   RIUMA Principal
    • Investigación
    • Artículos
    • Ver ítem
    •   RIUMA Principal
    • Investigación
    • Artículos
    • Ver ítem

    Belite clinkers with increasing aluminium content: effect of calcium aluminates on calcium silicate hydration

    • Autor
      Redondo-Soto, Cinthya; Gastaldi, Daniela; Irico, Sara; Canonico, Fulvio; García-Aranda, Miguel ÁngelAutoridad Universidad de Málaga
    • Fecha
      2022
    • Editorial/Editor
      Elsevier
    • Palabras clave
      Rietveld, Método de; Cemento
    • Resumen
      Belite cements (BCs) could have advantages over Portland cements concerning durability, low heat development and the use of less demanding raw materials. The activation of BCs by sulfur addition at the clinkering stage and by fast cooling is well established. However, the reaction rates of the calcium silicate phases, mainly belite, are still not fully understood. This is partly due to the interplay between factors including: i) belite activation during clinkering; ii) role of the calcium aluminates at early hydration ages; and iii) role of the sulfates. In the research reported here, three belite clinkers were prepared with constant values of lime saturation factor, and SO3, Fe2O3 and CaF2 contents. The varied parameter was the amount of Al2O3. The resulting clinkers have overall crystalline reactive calcium aluminate contents of 0.4, 7.9 and 16.7 wt%, respectively. Cements were prepared with similar particle sizes and constant anhydrite content. Here, it is shown that calcium silicate reactivities, both alite and belite, strongly depend upon the calcium aluminate contents. As these amounts increase, the degree of hydration of alite at 1 day decreases: 85, 65 and 50 %. Furthermore, the degree of hydration of belite at 7 days was 50, 35 and 0 %. Thus, there is a strong influence of aluminates in calcium silicate rates of hydration. Moreover, comparing the mechanical properties of the cements with 0.6 and 8.2 wt% amounts of calcium aluminates, the improvements due to the higher reactivity of calcium aluminates at very early ages, seem to be counterbalanced by the lower reactivity of the silicate phases. The reported findings may allow further optimization of early age reactivity of active BCs
    • URI
      https://hdl.handle.net/10630/25336
    • DOI
      https://dx.doi.org/10.1016/j.cemconres.2022.107015
    • Compartir
      RefworksMendeley
    Mostrar el registro completo del ítem
    Ficheros
    2022_10_05_CCR_BC-variable Al content clinkers_postcript-clean.pdf (569.0Kb)
    Colecciones
    • Artículos

    Estadísticas

    REPOSITORIO INSTITUCIONAL UNIVERSIDAD DE MÁLAGA
    REPOSITORIO INSTITUCIONAL UNIVERSIDAD DE MÁLAGA
     

     

    REPOSITORIO INSTITUCIONAL UNIVERSIDAD DE MÁLAGA
    REPOSITORIO INSTITUCIONAL UNIVERSIDAD DE MÁLAGA