Mostrar el registro sencillo del ítem

dc.contributor.authorSevilla-Hurtado, Lorenzo 
dc.contributor.authorTrujillo Vilches, Francisco Javier
dc.contributor.authorMarcos Bárcena, Mariano
dc.date.accessioned2013-07-04T10:46:01Z
dc.date.available2013-07-04T10:46:01Z
dc.date.issued2013
dc.identifier.citationProceedings of MESIC 2013es_ES
dc.identifier.urihttp://hdl.handle.net/10630/5593
dc.description.abstractThe arithmetical average roughness, Ra, is widely used to evaluate the quality of surface finish in machining parts. Its value depends on cutting parameters: cutting speed, feed and cutting depth. It is necessary to optimize the value of these parameters to achieve the desired quality, especially in the absence of cutting fluids. In this work, a study of the superficial quality of test bars, turned in dry, of an AL-Zn UNS A97075 alloy is presented. The value of Ra has been analyzed along the axial machining length for a series of test-pieces obtained under different combinations of cutting parameters values. The obtained results confirm that feed has the biggest influence. Finally, a potential relationship between Ra, cutting parameters and machining time has been obtained. This relationship allows predicting the behavior of Ra in the range of cutting parameters considered, along the machining time.es_ES
dc.description.sponsorshipUniversidad de Málaga – Campus de Excelencia Internacional Andalucía Teches_ES
dc.language.isospaes_ES
dc.publisherUniversidad de Zaragozaes_ES
dc.rightsinfo:eu-repo/semantics/openAccess
dc.subjectCortees_ES
dc.subject.otherDry-Turninges_ES
dc.subject.otherUNS A97075es_ES
dc.subject.otherRoughnesses_ES
dc.subject.otherCutting Parameterses_ES
dc.titleInfluence of the Axial Machining Length on Microgeometrical Deviations of Horizontally Dry-Turned UNS A97075 Al-Zn Alloyes_ES
dc.typeinfo:eu-repo/semantics/bookPartes_ES
dc.centroE.T.S.I. Industriales_ES


Ficheros en el ítem

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem